SIMPLORER User Manual V6.0 - FER-a

5
220 Modeling with Block Diagrams
Random
Amplitude AMPL real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
Magnitude AC Analysis AC_MAG real
Phase Shift AC Analysis [deg] AC_PHASE real
>>Basics>Blocks>Source Blocks
The block provides to each simulation step a random number within the defined range of values
at the block output.
MIN ≤
y( k)
≤ MAX
Dialog Settings
«Maximum Value»«Minimum Value»
Defines the maximum and minimum output value of the random function. Enter a numerical
value, a variable, or an expression in the text box.
� «Sample Time»
Select «System» for simulator-defined variable sample time. Select «Value» to define a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
AC Parameters
� «Phase & Magnitude»
The Phase/Magnitude representation is selected. Common parameter types. Enter a numerical
value, a variable, or an expression in the text box. See also “AC Simulation Models” on
page 401.
� «Angular Dimension»
In the list, select radians or degrees for the angular dimension of the phase.
� «Real & Imaginary»
The Real/Imaginary representation is selected. Common parameter type. Enter a numerical
value, a variable, or an expression in the text box.
Component Parameters
Description [Unit] Parameter Name Data Type
Maximum Random Value MAX real
Minimum Random Value MIN real
Sample Time [s] TS real