SIMPLORER User Manual V6.0 - FER-a

Component Parameters
Event Triggered Value
SIMPLORER 6.0 — Manual 257
Description [Unit] Parameter Name Data Type
Start Event STARTEVENT real
Stop Event STOPEVENT real
Component Outputs
Description [Unit] Parameter Name Data Type
Period [s] VAL real
>>Basics>Signal Characteristics>General Parameters
The macro provides the value of a variable, calculated when a specified event (condition)
comes true. The logical expression for the event must conform to the syntax of the SIMPLOR-
ER expression interpreter.
VAL = x( EVENT)
if EVENT=TRUE
Dialog Settings
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Event»
Logical parameter type. Enter a numerical value, a variable, an expression in the text box.
The expression is interpreted as TRUE if the provided value is '1'. Otherwise the value is
FALSE. The expression must be compliant to the SML syntax rules. See also “Equations, Expressions,
and Variables” on page 32.
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal INPUT real
Event for Measurement EVENT real
Component Outputs
Description [Unit] Parameter Name Data Type
Value at Event VAL real