SIMPLORER User Manual V6.0 - FER-a

16
510 Symbol Editor
Creating Interactions
�
Open the dialog to
select the control quantity
Create new entry
Select the displayed
Symbol levels, '0' is already visible
A symbol with interaction zones can be assigned parameter values before the simulation start
by clicking on the interaction zone (e.g., setting the starting point in state graphs). In addition,
the symbol’s appearance can also be changed (e.g., a marked state has a blue point).
The interaction function is available only for macro models that have the entry “LevelID” in
their parameter line. The LevelID parameter are assigned to the value, defined in the symbol.
See also “Creating Your Own Models (Components)” on page 489.
Create an interaction area with the DRAW>INTERACTIVE PANEL command. Draw the panel to
the size desired by holding and then releasing the mouse button. Double-click the panel to
open the property dialog.
This rectangular area is visible in the Schematic only if the element is selected. When you
click the area, the component receives the value defined in the «Panel Properties» dialog.
The figure shows the definition of the ID value assigned to the “LevelID” parameter in the
macro.
�
�
Non-conservative
component nodes
ID-Value