SIMPLORER User Manual V6.0 - FER-a

5 The new pin symbol can now be connected with the
wiring.
6 Establish non-conservative nodes in SHEET>SUB-
SHEET>CREATE PIN/PARAMETER.
SIMPLORER 6.0 — Manual 59
Non-conservative nodes are used to change parameters and to built graphical connections
in block diagrams and state graphs. Non-conservative nodes need the additional
information whether the pin should be used as input, output, or input and output.
Please note: There is a pin symbol for each non-conservative node, also when the pin is
not connected with a model parameter.
7 Switch to the next higher model level with «Level Up» in the subsheet shortcut menu.
8 Double-click the subsheet symbol to open the property dialog and to define parameters.
The subsheet is now created and is regarded as a normal component in the system. To edit
the subsheet, select the symbol and choose «Open» on the shortcut menu or choose SUB-
SHEET>OPEN.
Creating From Selection
Define the parameter name
When existing components on the sheet should be summarized as subsheet, you can select
the components and choose SHEET>SUBSHEET>NEW GRAPHICAL FROM SELECTION. This function
transfers all selected component into the subsheet.Conservative nodes are automatically
created and connected.
1 Define the model structure you want in the main sheet.
2 Mark all components which should be part of the subsheet.
3 Choose SHEET>SUBSHEET>NEW GRAPHICAL FROM SELECTION.
4 The subsheet with the selected components and the pins are created and opened. Define
more parameters for inputs and outputs if required.