SIMPLORER User Manual V6.0 - FER-a

Component Outputs
Power and Energy
SIMPLORER 6.0 — Manual 271
Description [Unit] Parameter Name Data Type
Sliding RMS Value VAL real
>>Basics>Signal Characteristics>Special Waveform Parameters
The macro provides the power and energy for a specified current and voltage within a given
interval.
P = V⋅I E =
V ⋅I ⋅t
Dialog Settings
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Start Time [s]»«Stop Time [s]»
Common parameter type. Enter a numerical value, a variable, or an expression in the text box.
The specified start time (for beginning of calculation) has to be less than the end time (for end
of calculation).
Component Parameters
Description [Unit] Parameter Name Data Type
Input Signal Voltage INPUT_V real
Input Signal Current INPUT_I real
Start Time [s] TSTART real
Stop Time [s] TSTOP real
Component Outputs
Description [Unit] Parameter Name Data Type
Power POWER real
Energy ENERGY real