SIMPLORER User Manual V6.0 - FER-a

5
208 Modeling with Block Diagrams
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Memory
Component Parameters
Description [Unit] Parameter Name Data Type
Differential Gain KD real
Initial Value for t=0 Y0 real
Upper Limit UL real
Lower Limit LL real
Input Signal INPUT real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
>>Basics>Blocks>Continuous Blocks
The block represents a delay of one simulation step of the input signal with initial value. You
cannot define a special sample time for the block.
yk ( ) =
xk ( – 1)
Dialog Settings
«Initial Value»
Defines the value for t=0. Enter a numerical value, a variable, or an expression in the text box
to define the initial value at simulation start.
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
Description [Unit] Parameter Name Data Type
Initial Value for t=0 Y0[0] real
Input Signal INPUT real