SIMPLORER User Manual V6.0 - FER-a

Integrator
SIMPLORER 6.0 — Manual 205
� � «Use Pin»
If the box is checked, the gain is defined by the quantity connected to the pin, otherwise the
value in the text box is used.
� «Sample Time»
Select «System» for simulator-defined variable sample time. Select «Value» to define a numerical
value, a variable, or an expression in the text box or use the pin to connect a quantity.
Please note: The sample time must be a positive value.
� � «Use Pin»
If the box is checked, the sample time is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
«Input Signal»
Enter a quantity name used in your model sheet in the text box to define the input signal
(RLOAD.I, STEP.VAL, STATE.ST, VAR) or use the pin to connect a quantity. Please note: You
cannot use conservative nodes from circuits as input signal (N0002, GND).
� � «Use Pin»
If the box is checked, the input signal is defined by the quantity connected to the pin, otherwise
the value in the text box is used.
Component Parameters
Description [Unit] Parameter Name Data Type
Proportional Gain K real
Input Signal INPUT real
Sample Time [s] TS real
Component Outputs
Description [Unit] Parameter Name Data Type
Block output signal VAL real
>>Basics>Blocks>Continuous Blocks
The block represents an integration block with limitation and the possibility to reset the output
signal (Laplace-domain, Laplace-operator specified as s). The table shows the different
forms to reset the output signal of the integration block.
Reset Signal Trigger Set Description
0 Summation of input signal.
>0 0 Assign the output signal permanently to the trigger value.
0 1 Hold the last output value of output signal.