substitution request - Alliance Construction Solutions

1.04 QUALITY ASSURANCE:
5. Maintenance data for each piping specialty and valve specified, for inclusion in
the Operating and Maintenance Manual specified in Division 22.
A. Regulatory Requirements: Comply with the provisions of the following:
1. ASME B31.9, "Building Services Piping," for materials, products and installation.
Safety valves and pressure vessels shall bear the appropriate ASME label.
2. ASME "Boiler and Pressure Vessel Code," Section IX, "Welding and Brazing
Qualification," for Qualifications for Welding Processes and Operators.
3. Local Plumbing Code and Utility Department requirements.
4. Colorado cross connection control manual.
5. Latest edition of the Engineering Standards of the Denver Board of Water
Commissioners.
1.05 DELIVERY, STORAGE AND HANDLING:
A. Store piping in such a manner as to prevent sagging and bending.
B. Cap ends of piping when being stored.
1.06 SEQUENCING AND SCHEDULING:
A. Coordinate the size and location of concrete equipment pads. Cast anchor bolt inserts
into pad. Concrete, reinforcement, and formwork requirements are specified in Division
3.
B. Coordinate the installation of pipe sleeves for foundation wall penetrations.
1.07 EXTRA STOCK:
A. Maintenance Stock: Furnish one valve key for each key-operated wall hydrant, hose bibb
and faucet installed.
PART 2 – PRODUCTS
2.01 MANUFACTURERS:
A. Manufacturers: Subject to compliance with requirements, provide products by one of the
following in each category:
1. Hose Bibbs and Faucets:
Project No.: 10145
550 15 th Street Dual Brand Hotel
03/16/2012
a. Watts Regulator
b. Woodford
c. Nibco
d. Crane
221119 - 2 DOMESTIC WATER PIPING
SPECIALTIES