substitution request - Alliance Construction Solutions

D. Welder Certificates signed by Contractor certifying that welders comply with requirements
specified under "Quality Assurance" article.
E. Record Drawings: At project closeout, submit record drawings of installed systems
products; in accordance with requirements of Divisions 1 and 23.
F. Maintenance data for oil transfer equipment, for inclusion in Operating and Maintenance
Manual specified in Divisions 1 and 23.
1.04 QUALITY ASSURANCE:
A. Manufacturer's Qualifications: Firms regularly engaged in manufacture of fuel oil systems
products of types, materials, and sizes required, whose products have been in satisfactory
use in similar service for not less than 5 years.
B. Installer Qualifications: Firm with at least 3 years of successful installation experience on
projects with fuel oil systems work similar to that required for project.
C. Qualify welding processes and welding operators in accordance with ASME "Boiler and
Pressure Vessel Code, 11 Section IX, “Welding and Brazing Qualifications."
D. Regulatory Requirements: Comply with provisions of the following codes:
1. NFPA 31 - Standard for the Installation of Oil Burning Equipment, for oil piping
materials and components, oil piping installations, and inspection and testing of
fuel oil piping systems.
2. NFPA 37 - Standard for the Installation and Use of Stationary Combustion Engines
and Gas Turbines.
3. Uniform Mechanical Code and Denver Building Department Code.
4. BOCA Basic National Mechanical Code.
5. Local fire department authority.
6. EPA guidelines and regulations.
E. UL Compliance: Provide fuel oil piping components which are listed and labeled by UL.
1. UL 343 - "Standard for Pumps for Oil-Burning Appliances,” for oil transfer pumps.
2. UL 567 - "Pipe Connections for Flammable and Combustible Liquids and LP-Gas,”
for pipe connectors for fuel oil piping systems.
3. UL File MH 1316 - "Standard for Glass-Fiber Reinforced Plastic Underground
Storage Tanks for Petroleum Products," for oil storage tanks.
4. American Petroleum Institute Std. 650, Welded Steel Tanks for Oil Storage
(ANSI/API Std 650-78).
1.05 SEQUENCING AND SCHEDULING:
A. Coordinate the size and location of concrete ballast pads and fill at sounding boxes for
housekeeping equipment pads for oil transfer pumps. Cast anchor bolt inserts into pad.
Concrete reinforcement and formwork requirements are specified in Division 3.
Project No.: 10145
550 15 th Street Dual Brand Hotel
03/16/2012
23 1113 - 2 FACILITY FUEL-OIL PIPING