Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsgetcrusGets CRU state informationDescriptionThe naviseccli or navicli getcrus command returns state informationon all or selected CRUs (customer replaceable units) in the storagesystem except for disks (see the getdisk command) and selectedFRUs/sub FRUs in the storage system. The getcrus commanddisplays the state of the following CRUs: fans, link controller cards(LCCs), storage processors (SPs), battery backup units (referred to asstandby power supplies or SPSs), and power supplies (PSs or VSCs).You can use getcrus without any switches to get the state informationfor every CRU (except disks). The getcrus command displays thestate of management module of FRUs and state of I/O module, CPUmodule, and DIMM of sub FRUs.Note: If one of the LCCs is pulled from Bus x, Enclosure x, all data along thatbus (after the LCC was pulled) appears as faulted since the agent cannotgather any information along that path. If this occurs, issue the getcruscommand to the peer SP. The CLI lists the faulted components.SyntaxPrerequisitesOptionsgetcrus is used with naviseccli (described on page 37) or navicli(described on page 45) as follows:getcrus [-cablingspsa] [-cablingspsb] -cachecard] [-cpua] [-cpub][-dimma] [-dimmb] [-encdrivetype] [-fana] [-fanb] [-fanc] [-fand][-fane] [-fanf] [-fang] [-iocarriera] [-iocarrierb] [-ioa] [-iob] [-lcca][-lccb] [-lccreva] [-lccrevb] [-lccsna] [-lccsnb] [-mgmta] [-mgmtb][-spa] [-spb] [-spsa] [-spsb] [-speeds] [-vsca] [-vscb] [-vscc] [-vscd]For naviseccli, you must have a user account on the storage systemon which you want to execute the command.For navicli, you must be able to log in to the host runningNavisphere CLI.Note: The command switches -cpua, -cpub, -dimma, -dimmb, -ioa, -iob,-mgmta, and -mgmtb are supported only on Secure CLI. The Classic CLIdoes not support these command switches.-cablingspsaReturns the cabling status for SPS A (standby power supply A).161