Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commands-rcb read-cache-spb (not supported on a single-SP AX4-5 series systemrunning Navisphere Manager)Enables or disables the read cache function for SP B. Forread-cache-spb:0 = Disables read cache1 = Enables read cache-wc write-cache (not supported on a single-SP AX4-5 series systemrunning Navisphere Manager)Enables or disables the write cache function. For write-cache:0 = Disables write cache1 = Enables write cache-wsz write-cache-size-sp (not supported on a single-SP AX4-5 seriessystem running Navisphere Manager)Sets the write cache size for the storage system towrite-cache-size-sp MB. Also, see the note on sizes under -rsza.Examples naviseccli -h ss1_spa getsp -memMemory Size For The SP: 930The getsp -mem command gets SP memory information. Each SP hasthe same amount of memory, so you need not issue this command forSP B.naviseccli -h ss1_spa setcache -wsz 650 -wc 1 -p 8-rcza 280 -rczb 280 -rc 1This command sets the write cache (applies to both SPs) to 650 MB,enables write caching, sets a write cache page size of 8 KB, sets a readcache size for each SP of 280 MB, and enables read caching.Note: To use this command with navicli, replace naviseccli with navicli.263