Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-hostScans the host initiator records and displays duplicate hosts withthe same host ID.The optional port -list switches are:Without arguments, -list displays information about all ports inthe system but does not list information given by -all,-arraycommpath, and -failovermode; this allows -list without anargument to produce output compatible with scripts written forNavisphere revisions 5.X. Example 1 below shows outputwithout switches; example 2 shows CLI 6.0.5 output with the -allswitch.You can use one of the following optional switches with -list:-allLists all port information, including any information that is newwith this Navisphere release. For script compatibility withrevisions of Navisphere before 5.3, use the -list without anargument.-arraycommpathDisplays the status of the arraycompath setting: 0 ifarraycompath is disabled; 1 if arraycommpath is enabled.-arrayhbaDisplays information about all storage systems attached to thisHBA, or about storage systems that were logged in at some pointand for which initiator records still exist. See Example 2 for adisplay.-breadDisplays the number of blocks read for each port.-failovermodeDisplays the failover mode: 0, 1, 2, 3 or 4. See the storagegroup-failovermode description for more information.-gname StorageGroupNameSpecifies a storage group. StorageGroupName specifies theuser-defined storage group name. If you omit the -gname and the-uid switches, the CLI describes all HBA ports connected to thisstorage group.293