Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands3Failover mode 3.4Failover mode 4.Example with failovermode:naviseccli -h ss1_spa storagegroup -sethost -failovermode 1-hostname server102Note: To use this command with navicli, replace naviseccli with navicli.-hostname [host]Specifies the HBA owner's hostname. You must specify thehost’s hostname or its IP address (-ip host-ip-address switch).-ip host-ip-addressSpecifies the IP address of the host, in the form xx.xx.xx.xx.You must specify either the IP address or the hostname. The IPaddress can be specified as IPv4 or IPv6 address. If anincorrect IP address is specified, the error message isdisplayed as follows: The IP address must be specifiedas an IPv4 address in dotted-decimal format or asan IPv6 address in colon-hexadecimal notation.-type initiatortypeSpecifies an initiator type to override the system default. TheCLI uses the default, 3, for the target if omitted. Type values(specify 0x to indicate hex) are0x2 HP (auto trespass)0x3 CLARiiON Open (default).0x9 SGI0xa HP (no auto trespass)0x13 Dell0x16 Fujitsu0x1c Compaq Tru64Note: AX series storage systems support only type 0x3.317