Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commands-globalprefix prefixChanges the SP’s IPv6 global prefix to prefix.–speed [-duplex] (CX4 series only)Changes the speed on the management port for the target SP.Note: The command switch -speed [-duplex] is supported only onSecure CLI. The Classic CLI does not support this command switch.-oExecutes the command without prompting for confirmation.OutputExampleSee the Description section. If the version of FLARE software runningon the SP does not support this command, a Not supported errormessage is printed to stderr. Other errors:NETADMIN_NOT_FOUNDNETADMIN_INVALID_NAMEInvalid command line parametersInvalid speed requestnaviseccli -h ss1_spa networkadmin -set -gatewayaddressChanging the gateway address of SP A from 123.456.789.011to 123.456.789.011 (y/n)[n] ySP A reboots.For the SP with hostname payroll_storage_SPA this commandchanges the gateway address.Note: To use this command with navicli, replace naviseccli with navicli.naviseccli -address 10.5.2.12 -user a -password a –scope 0networkadmin –set –ipv6 -manualThis command enables IPv6 (if not enabled) and maintains thecurrent settings.naviseccli -address 10.5.2.12 -user a -password a –scope 0networkadmin –set –ipv6 -manual -globalprefix 3ffe:80c0:22c:4c:This command enables IPv6 (if not enabled) and sets the IPv6 globalprefix.243