Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commands-write filenameWrites an image of the configuration file as it exists on the host orSP to file filename. The file is written in the same format as theagent.config file, which differs from the output of the getconfigfunction without the -write switch. You can use this file to set theconfiguration for other agents using the remoteconfig setconfig-f filename function. No other switch is allowed with -write.OutputExampleSee page 247. If the version of FLARE software running on the SPdoes not support this command, a Not supported error message isprinted to stderr. Other errors:RAC_AGENT_NOT_RUNNINGnaviseccli -h ss1_spa remoteconfig -getconfigThis command lists all agent information. Sample output is below.Note: To use this command with navicli, replace naviseccli with navicli.249