Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-alu alunumberSpecifies the storage-system LUN number, the actual LUNnumber internal to the storage system. This is the numberassigned when the LUN was bound. alunumber specifies thelogical unit number. This switch is required along with -hluand either the -gname or -uid switch.storagegroup command, -addsnapshot switch-addsnapshot -gname StorageGroupName| -uid StorageGroupUID-hlu hlunumber -snapshotname snapshotname|-snapshotuid snapshotuid-addsnapshot adds a SnapView snapshot to a storage group. Thestorage group you choose should be different from the sourceLUN storage group. You must use three of the following switcheswith -addsnapshot:-gname StorageGroupNameSets the name of the storage group. StorageGroupNamespecifies a user-defined storage group name; or-uid StorageGroupUIDSpecifies the storage group unique identification number.For Fibre Channel storage systems, the UID uses the WorldWide Name (WWN) format such as:10:00:00:00:C9:20:DE:0C:10:00:00:00:C9:20:DE:0C.For iSCSI storage systems, the UID uses the initiator namewhich uses the IQN format such as:iqn.1992-04.com.emc:cx.apm00034901792.b0.-hlu hlunumberSpecifies the host LUN number for the snapshot, which is theunique number that the storage-system server will see.hlunumber is the virtual LUN number.-snapshotname snapshotname | -snapshotuid snapshotuidSpecifies the snapshot name or unique ID number (WorldWide Name, WWN). One of these switches is required alongwith the -gname or -uid switch.310 EMC Navisphere Command Line Interface (CLI) Reference