Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-hbaReturns information on HBA ports. The initiator and target -hbafield returns different information depending on whether you aretargeting a Fibre Channel or an iSCSI HBA. When you target aFibre Channel HBA, the -hba returns the World Wide Name suchas: 10:00:00:00:C9:20:DE:0C:10:00:00:00:C9:20:DE:0C. When youtarget an iSCSI HBA, -hba returns the initiator name.-initiatorcountDisplays the initiator information for each port on a given SP.Lists the number of initiators that are defined, loggedin and notlogged in.-macDisplays the MAC address for the front-end ports of an iSCSIstorage system. Running the port ... -mac command returns aMAC Address field for each port. When you run the port ... -maccommand, if any ports are Fibre Channel ports, the MAC Addressfield for those ports will display Not Applicable.-physical (CX4 series only)Displays the physical location of the port including I/O moduleand physical port information.Note: Classic CLI does not support this command switch.-readsDisplays the number of reads for each port.-sfpstate(CX3 series only)Displays the small form factor pluggable (SFP) state for each port.This lets you determine if an incompatible or faulty SFP isdetected, in which the status is set to faulted.-spSpecifies SP ports only.-uid StorageGroupUIDSpecifies the storage group unique ID (also known as the worldwide name, WWN). If you omit the -gname and the -uidswitches, the CLI describes all HBA ports connected to thisstorage group.294 EMC Navisphere Command Line Interface (CLI) Reference