Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsExamplesnaviseccli –h ss1_spa networkadmin -get -speedStorage Processor SP AManagement Port SettingsLink Status: Link-upCurrent Speed: 100 Mbps/half duplexnaviseccli –h ss1_spa networkadmin -get -capablespeeds -autoStorage Processor : SP AManagement Port Settings:Link Status: Link-upCurrent Speed: 100 Mbps/half duplexAuto-Negotiate: NoCapable Speeds: 10 Mbps half/full duplex100 Mbps half/full duplex1000 Mbps half/full duplexAutonaviseccli -address 10.5.2.12 -user a -password a –scope 0networkadmin –get -ipv4 –ipv6Storage Processor: SP AStorage Processor Network Name: lumpy-spaStorage Processor IP Address: 10.5.2.12Storage Processor Subnet Mask: 255.255.255.0Storage Processor Gateway Address: 10.5.2.1Storage Processor IPv6 Mode: AutomaticStorage Processor IPv6 Address:3ffe:80c0:22c:4d:20d:56ff:fec5:bff4Storage Processor IPv6 Global Prefix: 3ffe:80c0:22c:4d::Storage Processor IPv6 Local Address:fe80::20d:56ff:fec5:bff4Storage Processor IPv6 Gateway Address:fe80::20a:8bff:fe5a:967cNote: The IPv6 information contains IPv6 in the header to distinguish theoutput from the IPv4 information.238 EMC Navisphere Command Line Interface (CLI) Reference