Navisphere Command Line Interface (CLI) Reference - VMware Communities

iSCSI (Internet SCSI) Commandsconnection -setportModify the properties of a portDescriptionSyntaxPrerequisitesOptionsThe naviseccli connection command with the -setport functionmodifies the properties of a specified SP port.connection -setport is used with naviseccli (described on page 37) asfollows:connection -setport -sp a|b -portid portid -address IPAddress-subnetmask subnetmask -gateway gateway [-initiatorAuthentication0|1] [-mtu mtu] [-o]You must have a user account on the storage system on which youwant to execute the command.-sp a|bSpecifies that the iSCSI port is on either SP A or SP B.-portid portidSpecifies the port on the SP. For example, an SP with one port hasport 1; an SP with two ports has port 0 and port 1.-address IPAddressSpecifies the IP address of the iSCSI port. The address uses thedotted-quad format. For example, 165.152.36.35.-subnetmask subnetmaskSpecifies the subnetwork mask for the iSCSI port. The subnetmask uses the dotted-quad format. For example, 255.255.255.0.-gateway gatewaySpecifies the network gateway address that the iSCSI port uses.The gateway address uses the dotted-quad format. For example,165.152.35.22.381