Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-usage (CX4 series only)Indicates how the port is used. For example, when either of theMirrorView enablers is installed, it displays MirrorView.Note: Classic CLI does not support this command switch.-unitserialnumberSpecifies the unitserialnumber mode.-writesDisplays the number of writes for each port.The optional port -removeHBA switches are:-hbauid hbauidRemoves a specific initiator record specified with -hbauid. hbauidspecifies a unique host bus adapter identification number (mustuse uppercase).-host hostnameRemoves all initiator records that are logged out and registered,for the specified hostname.-hostip IPAdressRemoves all initiator records that are logged out and registered,for the specified host IP address. You can specify the IP addresseither as IPv4 or IPv6 address. If an incorrect IP address isspecified, an error message appears as follows: The IP addressmust be specified as an IPv4 address in dotted-decimalformat or as an IPv6 address in colon-hexadecimalnotation.Note: If an IPv6 address is specified, EMC recommends that you use aglobal unicast address.-allRemoves all initiator records that are logged out and registered,for the specified storage system.-oExecutes the command without prompting for confirmation.295