Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commandsndu -listndu BackgroundDescribes installed SP driver software packagesThe ndu command provides nondisruptive upgrades on CX3 seriesand CX series storage systems. This command lets you install andupgrade storage-system software without disrupting any I/O fromattached servers. Third-party software installation is not supported.This means you can use ndu to install FLARE software or AccessLogix, MirrorView, and Snapview packages.Note: For AX series storage systems the process is disruptive.Use the -list function with no switches to display all the informationabout all software packages.Note: The ndu command is not supported on NetWare and HP-UX operatingsystems. The ndu command is only supported by Secure CLI in NavisphereCLI versions 6.24 and later.DescriptionSyntaxThe naviseccli ndu command with the -list function and no switchesdisplays information about all installed software packages. Theformat looks like this:Name of the software package: nameRevision of the software package: n.nnCommit Required:yes or no oralready committedRevert Possible:yes or noActive State:yes or noIs installation completeyes or no or notapplicable.Is this System Software:yes or noFor information on one package, use the -name switch. For a subsetof package information, use one or more additional switches.After listing installed driver packages, you can perform other ndu(non-disruptive upgrade) steps, such as ndu -commit or ndu -revert.ndu -list is used with naviseccli (described on page 37) as follows:ndu -list [-name [name]] [-rev] [-iscommitable] [-isrevertable][-isactive] [-iscomplete] [-issystem] [-gen]222 EMC Navisphere Command Line Interface (CLI) Reference