Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commandsioportconfig -persist (CX4 series only)Writes the port configuration information to persistent memory.DescriptionThe naviseccli ioportconfig -persist command writes all portconfiguration information on the subsystem to persistent memoryand reboots both SPs. You can specify the delay value for writing theport configuration information. If you do not specify the delay, thenthe system takes the default value of 360 seconds.Note: Classic CLI does not support this command.Syntax ioportconfig -persist is used with naviseccli (described on page 37)as follows:ioportconfig -persist [-delay delay] [-o]PrerequisitesOptionsOutputFor naviseccli, you must have a user account on the storage systemon which you want to execute the command.-delay delayDelays the coordinated reboot between SPs for the specifiedvalue. The value ranges from 0 to 1140 seconds. The default valueis 360 seconds.-oExecutes the command without prompting for confirmation.This operation will cause both SPs to reboot in acoordinated fashion. DO YOU WISH TO CONTINUE (Y/N)?Example naviseccli -h ioportconfig -persist -delay 20210 EMC Navisphere Command Line Interface (CLI) Reference