Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-uid StorageGroupUIDSpecifies the storage group unique ID.-hlu hlunumberhlunumber specifies the logical unit number, which is thenumber that the storage-system server will see.This switch isrequired along with either the -gname or -uid switch.storagegroup command, -removesnapshot switch-removesnapshot -gname StorageGroupName|-uid StorageGroupUID-snapshotname snapshotname|-snapshotwwn snapshotUID-removesnapshot removes a SnapView snapshot from a storagegroup. You must use one of the four following switches with-removesnapshot:-gname StorageGroupNameStorageGroupName specifies the user-defined storage groupname.-uid StorageGroupUIDSpecifies the storage group unique ID.-snapshotname snapshotname | -snapshotwwn snapshotUIDSpecifies the snapshot name or unique ID number (WorldWide Name, WWN). One of these switches is required.storagegroup command, -sethost switch-sethost [-host hostname | -ip host-ip-address[-arraycommpath 0|1] [ -failovermode 0|1|2 |3|4][-type initiator-type] [-unitserialnumber array|lun] [-o]The -sethost function creates or changes certain settings for allinitiators (HBAs) in the specified host that are connected to aspecific storage system. You must specify the host (-host switch),unless you are issuing the command in the current host. To obtain-sethost status, use the port list command. The -sethost functionhas subfunction switches as follows.Note: For AX4-5 series storage systems, the storagegroup command with the-sethost switch will accept nondefault values for the following switches:-failovermode, -arraycommpath, -type, and -unitserialnumber.314 EMC Navisphere Command Line Interface (CLI) Reference