Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsunitserialnumberDescriptionSyntaxPrerequisitesOptionsDisplays or changes the VDPP80 (port 80) behavior modeThe naviseccli or navicli unitserialnumber command displays or setthe VDPP80 behavior mode, which defines how subsequent VPDP80requests will be populated with the storage-system serial number.You might need to do this for software such as SunCluster 3.To set this mode for a specific storage group, see the storagegroupcommand in Chapter 4.unitserialnumber is used with naviseccli (described on page 37) ornavicli (described on page 45) as follows:unitserialnumber [array|lun] [-o]For naviseccli, you must have a user account on the storage systemon which you want to execute the command.For navicli, you must have a user entry in the Navisphere agentconfiguration file.arraySets the behavior mode to array (storage system).lunSets the behavior mode to LUN.-oExecutes the command without prompting for confirmation.Examples naviseccli -h ss1_spa unitserialnumberCurrent unit serial number mode is: LUNnaviseccli -h ss1_spa unitserialnumber arrayThese two commands display the current behavior mode and then setthe mode to array (storage-system) mode.Note: To use this command with navicli, replace naviseccli with navicli.287