Navisphere Command Line Interface (CLI) Reference - VMware Communities

3Basic CommandsThis chapter explains each of the basic variations, that is, the CLIcommands that are common to all CLARiiON disk-array storagesystems. Command variations for storage groups (Access Logixoption) are explained in the following chapter.Note: CLI commands for the EMC MirrorView /Synchronous software areexplained in the MirrorView/Synchronous CLI manual; CLI commands forthe EMC MirrorView/Asynchronous software are explained in theMirrorView/Asynchronous CLI manual; CLI commands for theEMC SAN Copy software are explained in the SAN Copy CLI manual; andCLI commands for EMC SnapView (for both snapshots and LUN clones)are explained in the SnapView admsnap and CLI manual.Major topics are:◆ Storage setup and management overview..................................... 52◆ alpa -get (not supported on iSCSI storage system)....................... 54◆ alpa -set (CX series only)................................................................... 56◆ arraycommpath (AX4-5 series running Navisphere Manager andCX series only).................................................................................... 58◆ arrayconfig -capture (CX series only) ............................................. 60◆ arrayconfig -duplicate (CX series only) .......................................... 62◆ arrayname ........................................................................................... 65◆ backendbus -analyze (CX3 series only) .......................................... 66◆ backendbus -get -speeds (CX3 series only) .................................... 70◆ backendbus -get -sfpstate (CX3 series only) .................................. 72◆ backendbus -get -physical (CX4 series only) ................................. 73◆ backendbus -get -all (CX3 series and CX4 series only)................. 74◆ backendbus -resetspeed (CX3 series only) ..................................... 7649