Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsgetlunGets LUN informationDescriptionThe naviseccli or navicli getlun command returns information abouta LUN and the customer replaceable units (CRUs) that make up thatLUN.Note: For CX3 series and CX series storage systems, values returned for fieldsnoted with an asterisk (*) below may not be correct. Use NavisphereAnalyzer for the correct values.If statistics logging is disabled, some fields are not printed (switches markedwith * below). Other switches must be used with the -disk switch (switchesmarked with ** below).If the target LUN is a metaLUN, We recommend that you use the metlun -listcommand (see page 341) instead of the getlun command to returninformation about the metaLUN. If you use the getlun command, only thefollowing fields report data that apply to metaLUNs — Name, Currentowner, Default owner, LUN Capacity (Megabytes), LUN Capacity (Blocks),UID, Is Private, Snapshot List, MirrorView Name if any.If you target the LUNs that make up a metaLUN, all fields apply.Syntaxgetlun is used with naviseccli (described on page 37) or navicli(described on page 45) as follows:getlun lun-number [-aa] [-addroffset] [-at][-bind] [-bp*] [-bread**] [-brwsp *] [-busy**] [-busyticks] [-bwrite**][-capacity] [-crus ] [-default ] [-disk][-drivetype] [-dsa] [ -element][-ena**] [-etp*] [-ff*] [-hrdscsi] [-idle**] [-idleticks][-idt] [-ismetalun][-it ] [-itp* ] [-lunbusytickssp*] [-lunidletickssp*] [-luncache][-mirrorname] [-mp][-mt ] [-name] [-nanzq*] [-nminus] [-nzrca*][-offset] [-owner] [-parityelements] [-pd] [-pic ] [-prb] [-prefetch][-prf] [-ps ] [-private] [-psm] [-que] [-rb] [-rc ] [-reads**] [-ret] [-rg][-rhist*] [-rwf] [-rwrsp*] [-sc] [-sftscsi] [-slst*] [-slct*] [-snapshot][-sor*] [-sqlah*] [-srcp] [-ss] [-ssm] [-state] [-status] [-stripe] [-totque][-type] [-uid] [-upb*] [-usage ] [-verify][-was] [-wc] [-wch*] [-wh*] [-whist*] [-writes**]178 EMC Navisphere Command Line Interface (CLI) Reference