Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commandsnetworkadmin -getLists network name and address informationDescriptionThe naviseccli or navicli networkadmin command -get functionwithout switches lists all network information for an SP. Thiscommand supports IPv6 network communication to themanagement ports of storage systems with FLARE version 04.28 orlater. If you do not specify the IP address (either IPv4 or IPv6), thenby default IPv4 information is displayed. The default IP address isIPv4. If both the -ipv4 and -ipv6 switches are specified, theinformation is displayed for both IP addresses, with the IPv4information listed first.Issue the command to the SP for which this information is needed.Issuing this command with one or more switches displays theinformation based on the specified switch. The line StorageProcessor: is always displayed. This command displaysinformation in the following format:Storage Processor: SP-id (A or B)Storage Processor Network Name: SP-network-nameStorage Processor IP Address: SP-IP-addressStorage Processor Subnet Mask: SP-subnet-maskStorage Processor Gateway Address:SP’s-gateway-system addressNote: If you need to change an SP network name or address, you can do sowith the networkadmin -set function described on page 241.Only Classic CLISyntaxnetworkadmin -get is used with naviseccli (described on page 37) ornavicli (described on page 45) as follows:networkadmin -get [-name][-ipv4 [-address] [-subnetmask] [-gateway]][-speed][-auto] [-capablespeeds] [-requestedspeed] [-linkstatus][-all]networkadmin -get [-name][-ipv6 [-address] [-globalprefix] [-gateway] [-mode]][-speed][-auto] [-capablespeeds] [-requestedspeed] [-linkstatus][-all]235