Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsNote: If you have the Auto-Negotiate feature turned on, the Speed Valuethat is generated in the output does not have a value of auto. The valuereflects the speed at which the port is currently operating. If you have theAuto-Negotiate feature turned on and you specify the -requestedswitch, the Requested Value displays a value of auto.-availIndicates the available speeds for a specified port.-requestedDisplays the speed requested throughspportspeed -set. Thespeed that is requested may not equal the actual speed of the port.For example when the Auto-Negotiate feature is turned on, theRequested Value displays auto and the Speed Value displays thespeed at which the port is currently operating.-typeDisplays the connection type (Fibre Channel or iSCSI) for eachport along with the speeds.-physical (CX4 series only)Displays the physical location of the port.Note: Classic CLI does not support this command switch.orspportspeed -set -sp sp –portid port speedNote: If an incompatible small form factor pluggable (SFP) is detected, theport is faulted and you will not be able to set the SP port speed.where:-sp spSpecifies the SP to set the port speed on a|b.-portid port speedport specifies the port on the SP (0, 1, 2, or 3).speed specifies the port speed: See the note above. For FibreChannel systems, port speed is 1 for 1-Gb mode, 2 for 2-Gb mode,4 for 4-Gb mode, auto to initiate the Auto-Negotiate feature. For280 EMC Navisphere Command Line Interface (CLI) Reference