Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic CommandsSyntaxPrerequisitesOptionsbind is used with naviseccli (described on page 37) or navicli(described on page 45 ) as follows:bind raid-type [lun] -rg rgID[-aa auto_assignment] [-cap capacity] [-elsz stripe-element-size][-noinitialverify][-offset logical-block-address] [-pl placement][-r rebuild-priority] [-rc read-cache] [-sp a|b] [-sq size-qualifier][-v verify-priority] [-wc write-cache]To create a hot spare RAID group for AX4-5 series and CX seriesstorage systems, use the following syntax:bind raid-type [lun] disks [-aa auto_assignment] [-c cache-type][-elsz stripe-element-size] [-n min_latency_reads] [-noinitialverify][-sp a|b] [-r rebuild-priority] [-v verify-priority] [-z stripe-count]For naviseccli, you must have a user account on the storage systemon which you want to execute the command.For navicli, you must have a user entry in the Navisphere agentconfiguration file.raid-typeSpecifies the RAID type for the LUN.r0 = RAID 0r1 = RAID 1r3 = RAID 3r5 = RAID 5r6 = RAID 6r1_0 = RAID 1/0id = individual diskhs = hot spareNote: RAID 6 is available only for CX series storage systems runningFLARE 02.26.xxx.5.yyy or higher, for CX3 series storage systems runningFLARE 03.26.xxx.5.yyy or higher, for CX4 series storages systems, andfor AX4-5 series storage systems running FLARE 02.23.050.5.7xx orhigher.Note: All RAID types are not supported on all storage systems.83