Navisphere Command Line Interface (CLI) Reference - VMware Communities

Basic Commandsnaviseccli -h ss1_spa bind r1 2 -rg 2Binds a LUN of type RAID 1 (mirrored pair) with LUN ID 2 onRAID group 2. The LUN occupies all space on RAID group 2, andcaching is enabled by default.naviseccli -h ss1_spa bind hs -rg 3Binds a hot spare on RAID group 2. The hot spare has no LUN ID(it is not really a LUN) and occupies all space on RAID group 2.3. Get SP memory information to prepare to set up thestorage-system cache.naviseccli -h ss1_spa getsp -memMemory Size For The SP: 930Each SP has the same amount of memory, so you need not issuethis command for SP B.4. Set up storage-system caching with 70% memory for writecaching and 30% for read caching.naviseccli -h ss1_spa setcache -wcza 650 -wc 1 -p 8-rcza 280 -rczb 280 -rc 1This command sets the write cache for SP A (applies to both SPs)to 650 MB, enables write caching, sets a write cache page size of 8KB, sets a read cache size for each SP of 280 MB, and enables readcaching.For easy identification in the future, name the storage system.naviseccli -h ss1_spa arrayname users11Change the arrayname from xxx to users11? (y/n) yThis command changes the name of the storage system tousers11.At this point, you can create file systems (run the appropriate hostcommand) on the LUNs from the operating system and store data onthem.You can learn LUN device names using the getagent command andcheck status periodically using the getsp, getdisk, and/or getluncommands.53