Navisphere Command Line Interface (CLI) Reference - VMware Communities

Domain and Security Commands-keyvalue kval1< kval2...>Specifies the list of key values.Is required if serverkey is specified. If server authentication is notdesired, keyvalue is not required.Enclosure key values in quotation marks.Empty value is simply a pair of quotation marks (for serverkeyvalue = 0).An ordered list is in the same order as serverkey above.Every server key must have a key value.Valid key values are printable ASCII characters excluding thespace character and the # character. If specified, the length of eachkey must be between 1 and 16 characters (empty value isdescribed above).OutputExampleVaries depending on the switch you use.naviseccli -address ss1_spa -set -start yes -interval 45 -servers10.5.1.207 128.222.132.13 -serverkey 1 5 -keyvalue"1234567812345678" "abcdefghabcdefgh"Specifies all items for ss1_spa including server authentication.naviseccli -address ss1_spa -set -start yes -interval 45 -servers10.5.1.207 128.222.132.13 -serverkey 5 0 -keyvalue"1234567812345678" ""Specifies all items for ss1_spa including server authentication but thekey for addr2 is not specified.naviseccli -address ss1_spa -set -start yes -interval 45 -servers10.5.1.207Specifies items for ss1_spa choosing not to use server authentication.naviseccli -address ss1_spa -set -start noStops (disables) NTP operations for ss1_spa.Note: Does not affect synchronization interval or servers settings.433