Navisphere Command Line Interface (CLI) Reference - VMware Communities

Access Logix (Storage Group) Commands-unitserialnumber [array|lun]The unitserialnumber command displays or sets the VDPP80behavior mode, which defines how subsequent VPDP80requests will be populated with the storage-system serialnumber. You might need to do this for software such asSunCluster 3. You can discover the mode with theport -list -unitserialnumber or port -list -all command. To setthis mode for a host, see storagegroup -sethost above.arraySets the behavior mode to storage system.lunSets the behavior mode to LUN.Note: Not supported on AX series storage systems.Example with unitserialnumber:naviseccli -h ss1_spa storagegroup -sethost-unitserialnumber lunNote: To use this command with navicli, replace naviseccli with navicli.storagegroup command, -setpath switch-setpath [-gname StorageGroupName| -uid StorageGroupUID][-arraycommpath 0|1] [-failovermode 0|1|2 |3|4][-hbauid hbauid] [-host hostname] [ -ip ip-address][-sp a|b] [-spport 0|1] [-unitserialnumber array|lun] [-o]Creates or changes settings for a specific initiator (HBA). Youmust specify the HBA (-hba switch), SP (-sp), and SP port(-spport). You can identify the storage group by name (-gnameswitch) or unique ID (-uid switch). If you omit both switches, theCLI uses the default path. To obtain -setpath status, use theport list command. The -setpath function has many functionswitches as follows.Note: The storagegroup command with the -setpath switch is supported onAX4-5 series storage systems, but is not supported on other AX series storagesystems.318 EMC Navisphere Command Line Interface (CLI) Reference