ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

104 Creating an Instrument Control Method
time program is similar in principal to that described above in the chapter
Instrument Setup – Pumps, Pump Program.
The Time, Excitation wavelength, and Emission wavelength values
must be entered manually, whereas the options Autozero, Event Out,
and Event Mark can be checked separately for each time line. Event Out
short circuits the event out terminal for approximately 1 second. Event
Mark adds an event mark to the analog output.
The values for the Sensitivity, Gain, Recorder Range, and the Output
Mode can be selected from the pull-down menus. Fields with selections
available will display a combo-box button when the field or row is
selected. Click the button to display the available choices.
The available choices for the sensitivity are HIGH, MED, and LOW. F or
the Output Mode the available choices are Excitation Energy, Light
Source Correction, and Emission NOT corrected.
Fig. 153 pull down menus in the Fluorescence Detector RF-10Axl setup
Instrument Setup – Alltech 650 Conductivity Detector
The Alltech 650 conductivity detector supports the general detector
settings described on page 91.
Fig. 154 Alltech 650 conductivity detector setup window
Temperature Control
Enter the desired temperature of the measuring cell, the allowed
temperature tolerance and the waiting time for conditioning.
Program table
The program table can be edited in the usual way. For any time window
you can select the range and the polarity of the signal via drop-down lists.
The choice for the range is 0.01, 0.05, 0.10, 0.50, 1.00, 5.00, 10, 50, 100,
500, 1000, and 5000 µS.
Instrument Setup – User defined Detector
For any user defined detector only the general detector settings,
described on page 91, can be set.