ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Creating an Instrument Control Method 95
Instrument Setup – Kontron Detectors
(3xx, 4xx, and 5xx)
Fig. 138 Kontron Detector setup window
Except the not available option Acquisition Channel On/Off the general
detector settings as described on page 91 can be made. Additionally the
range can be set to define the range of the analog detector outputs. The
choice is 0.100, 0.200, 0.500, 1.000, and 2.000 Absorption Units Full
Scale (AUFS).
The Kontron x30 and x35 detectors can be used in a dual channel mode.
As far as the option Used Channel #2 is checked, a second wavelength
column will appear in the spreadsheet below. Also the otherwise not
accessible cycle time becomes active for changing. This defines the
alternating measuring time for the two channels. The data acquisition is
not performed truly simultaneously. The cycle time you can set within the
range of 0.40 through 1.00 seconds with 0.05 s increments.
For the x32 detectors the option Used Channel #2 is not available and
the cycle time is not displayed at all.
The wavelength table is a spreadsheet to enter your time (detector)
program. In the first row (at time 0.00 min), enter the initial wavelength(s)
in nm. The editing principle is the same as for the time (gradient)
program, described in the chapter Instrument Setup – Pumps, Pump
Program.
Instrument Setup – K-2600 Detector
The detector K-2600 supports the general detector settings described on
page 91.
The appearance of some of the details of the K-2600 detector tab
depends on the availability of a PDA option.
Fig. 139 Detector K-2600 setup window with PDA option