ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Creating an Instrument Control Method 169
Direct Control
Temperature (°C)
The oven temperature can be set. The entered value will be transferred
to the oven by clicking the Set button.
Cooler Temperature (°C) (S 4050 only)
The oven temperature can be set. The entered value will be transferred
to the oven by clicking the Set button.
Leakage Alarm Level (%) (S 4050 only)
The leakage alarm level can be set. The entered value will be transferred
to the oven by clicking the Set button.
Digital Outs (Events) (S 4050 only)
Click on the button to set up the digital outputs. Refer to the chapter
described in the chapter Instrument Setup – Pumps, section Configuring
Digital Outputs for details. Click the DO Apply button to accept the
settings.
Set Temperature Control (S 4050 only)
Press the Off button to switch the temperature control off. It will be
switched on again by setting the desired temperature and pushing the
Set button.
GLP (S 4050 only)
The minimum and maximum reached temperatures, the total working
time and the working time above 150°C will be monitored. The read out
will be actualized by clicking on the Refresh button.
Instrument Status – Flowmeter
Fig. 248 Status tab, Knauer Flowmeter
Monitor
Run Status
The status HOLD will be displayed when no program is running;
otherwise the Run Status displays a run time in minutes elapsed from the
start of the run.
Flow (ml/min)
The actual flow will be shown in units as defined in the instrument setup.