ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Knauer Instrument Control Method Options 171
If you click the button, three additional options are
available.
Fig. 250 Knauer Instrument Control Method Option - Advanced Runtime Settings
Check run time when saving method
ChromGate allows different run times for all devices. If you wants to have
the same run time for all devices and let the software check if, e.g. after a
change, all devices have the same run time, enable this option. If there
are different run times, the software displays an error message with the
run time of all devices. The run times must be equalized before you can
save the message.
Fig. 251 Error message Run time check failed
If enabled, this option is valid for all instruments of the Enterprise; it
is not limited on the currently used instrument or computer. That
means, that the run time will checked for all instruments and
therefore in all methods that will be stored on the mentioned
Enterprise machine.
System wake-up and all lamps on
If the option “System wake-up and all lamps on” is enabled and a date
and time is selected, all device, switched to Standby and the lamps of all
connected detectors will be switched on at the selected time. The method
must be opened and the detectors switched on or in Standby at this time.
The wake-up date time you can set by direct editing the time in the dateand-time
line. If you click on the arrow key , you can select a date from
a monthly overview (refer to the picture below).
Please note, that Standby only works for all Azura and the newer
Smartline devices pump S 1050 and detectors S 2550 und S 2520. Older
Smartline devices as pump S 1000, detector S 2600 cannot wake-up
from Standby by a software command; also the lamp of the detector
cannot be switched on, if the detector is in Standby.