ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

66 Setup and Control of Knauer HPLC Systems
Fig. 94 Tray configuration 84+3 vials for the autosampler 3950
The “84+3 vial” tray for the autosampler 3950 is supported in
firmware version 1.14 or higher. A firmware upgrade from former
firmware versions is not available.
Left (Right) tray type
Select the type of the installed tray for both sides. The choices are
96 low, 96 high, 384 low, 48 vials, and 12 vials. The selection can
be different for each tray side. In case of activated prep mode it is
fixed on 12 vials. If the tray type 84+3 vials is enabled, this choice is
for both side; this tray uses the left and right tray side. Only for the tray
type 84+3 vials it is possible to select a source vial for the transport
liquid in the method setup later. The 84+3 vials tray is only available
for autosamplers with firmware version 1.14 or higher. Autosamplers
with a previous firmware version cannot be updated.
Plate process order
The vials of the two trays will be processed either in columns or rows
order.
First Destination Vial
Enable this option if you want to use destination vials. Enter the first
destination vial position. For each injection a destination vial will be
used for mixing a diluting.
Reagent A(B) Vial
Enable these options if you want to use reagent vials. Enter the
corresponding vial position. The selected vial will be used for Reagent
A and/or Reagent B for all injections.
Use Mix & Dilute
Enable this option to select for each injection one destination, reagent
A and reagent B vial (position). This allows a higher number of
injections if a higher volume of the reagent(s) is required.
The Mix & Dilute option is only available if you have selected the
same tray type for left and right. It is not available for the tray type
84+3 vials.