ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

18 Short guide ChromGate®, KNAUER Instrument Control
Fig. 12 UV Detector S 2600 tab
Autosampler Tabs
Different autosamplers can be controlled by the ChromGate ® software.
Any method window will include the tab for the configured one, to setup
the needed injection parameters. You will find detailed setup information
for the autosamplers starting on page 111.
Fraction Collector Tabs
Several fraction collectors including the Knauer multi valve FC and a
virtual one can be controlled by the ChromGate ® software. Any method
window will include the tab for the configured one, to setup the needed
control parameters. You will find detailed setup information for the
fraction collectors on page 235.
Miscellaneous Instrument Tabs
Further instruments to be controlled by this software are:
Manager 5000/5050, IF2 (analog/digital outputs of the Knauer A/D
converters
Knauer Switching Valves
Valco Switching Valves
Column oven 4050, Jetstream oven
Flowmeter
For each of them a tab will be shown in the method window as far as the
instrument has been configured. If you have included more the one of the
Knauer or Valco Switching Valves from one configuration window, even if
they are of different type (K-6, K-12, or K-16) they are represented
together in one tab. The detailed description is given on page 131.
Baseline Check tab
The Baseline Check tab is presented if Baseline Check is selected on the
Configuration Options dialog box (see section Setting up the Baseline
Check on page 136). It is used to ensure that the baseline is satisfactory.
The Baseline check must be enabled in the Options menu of the
instrument configuration.