ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

56 Setup and Control of Knauer HPLC Systems
Channel 2 Input:
Select the second connected data channel of your interface. It can be
deactivated by the selection . The Kontron x32 detectors are
automatically set to .
Y-Axis Units
Select the type of units to be displayed on the y-axis of your
chromatogram from the drop-down list. The choices are AU (Absorption
Units), mAU (0.001 AU) or µAU (0.000001 AU) and ADC counts.
Configuration – Kontron Diode Array Detectors
Fig. 80 Kontron DAD configuration window
The Kontron PDA detectors are controlled similar to the Knauer detectors
via the configured RS232 port.
Name
Enter a descriptive name for the detector. This name will appear on the
detector tab when the instrument setup or status windows are displayed.
The name must be unique within the instrument.
Serial Number
Type in the serial number of the detector you are using.
Interface
For the diode array detectors, the choice is PCI and LAN. If you control
the DAD via the LAN, you must enter the IP Address. The access to the
IP Address field is blocked if PCI was selected.
Y-Axis Units
Select the type of units to be displayed on the y-axis of your
chromatogram from the drop-down list. The choices are AU (Absorption
Units), mAU (0.001 AU) or µAU (0.000001 AU) and ADC counts.
Selecting the ADC counts, the signal mode in the Instrument setup
(page 102) will be indicated as ‘Intensity’ without access for
changing it. This change you can perform in the configuration
window only.
Flow Cell
Enter a description for the flow cell you are using. The description will be
printed out when you print the instrument configuration.
Channels
Up to four channels can be activated. According to the selected number
the fields Chn.Name #1-4 become accessible for editing.