ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

38 Setup and Control of Knauer HPLC Systems
A list of available analysis options will be presented.
Fig. 43 analysis options window
Click the box(es) to select the optional software you want to enable for
this instrument. The additional licenses are required beside the Baseline
Check. For more information regarding the option, please check the
System Options part above on page 14. The Knauer Fraction Collectors
Control option (FRC) must not been enabled here. Whenever a
configuration with a fraction collector is started, an installed FRC license
will be activated.
Configuration – Knauer Pumps
For each pump in the Configured Modules window, double-click the icon
and complete the configuration dialog.
For configuration information regarding the PLATINblue pump P-1,
please refer to the PLATINblue system manual.
If the pump S 1050 should be controlled by RS-232, in the pump’s
own setup the “Interface” must be set to “RS232 115200”. Please
refer to the pump’s manual, chapter “Setup menu” for more
information.
The pumps K-1000, K-1001, S 1000 and K-1800 (preparative pump
1800) only can be controlled with ChromGate, if the pump’s internal
communication in the menu option “CONTROL” is set to “NET baud
rate 9600”.
To control a pump K-501, in the pump’s internal setup the menu
option “CONTROL” must be set to “Ext:RS232”. The firmware
version must be v. 1.23 or higher.
If you are operating a K-1001 pump fitted with a firmware version
< 5.x, you must select the K-1000 icon for configuration. This is due
to the status information, which the older firmware does not
support. Otherwise you will get error messages when the pump
starts running. For those pumps no advanced status information
and no pressure trace recording are available.