ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

150 Creating an Instrument Control Method
D2 Lamp (HAL Lamp)
The On state of the lamp(s) is represented by a green active LED symbol
( ), the Off state is represented by an inactive gray LED symbol ( ).
Clicking on the Lamp Off button will (after inquiry) switch the lamp off
and change the button label to Lamp ON. The appearance of the HAL
lamp control depends on the individual detector and its configuration.
Autozero
Click this button to define the current signal (over the specified spectrum)
as the baseline zero level.
Digital Channels (nm)
The number of channels that will be activated depends on how many
possibilities are given to set new values for the measuring wavelengths.
Pressing the WL Apply button forces the wavelength change on the
detector channels.
Events (Digital Outs)
Click the button to set up the digital outputs. Refer to the chapter
Instrument Setup – Pumps, Pump section Configuring Digital Outputs for
details. Click the Events Apply button to accept the settings. For
detectors without the feature of digital outputs this area is grayed and
inaccessible.
The D2 lamp should be switched on manually from the Direct
Control window before starting the next working session. After
power up, allow 30 minutes for the lamp to stabilize before running
samples that may require sensitive measurements.
Info
Click this button to display the device specific data in the detector
information tab.
Fig. 224 Detector information window
Diagnostics
Click this button to use the diagnostic features of the ChromGate ®
software. The Diagnostics window appears which allows you to access
information and to control important parameters and modules of the
device.