ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Setup and Control of Knauer HPLC Systems 55
Configuration – Kontron UV-Detectors
Fig. 79 Kontron detector configuration windows
The Kontron detectors are controlled similar to the Knauer detectors via
the configured RS232 port. For the data acquisition, the analog output
with an A/D card or box must be used.
Name
Enter a descriptive name for the detector. This name will appear on the
detector tab when the instrument setup or status windows are displayed.
The default detector name will be suggested automatically by selecting
the detector type. The name must be unique within the instrument.
Type
Select the type of your detector.
Serial Port
Select the number for the communication port on your PC where the
instrument is connected. The selection is for simulations. No real
control of the instrument will be performed.
Serial Number
Type in the serial number of the detector you are using.
Flow Cell
Enter a description for the flow cell you are using. The description will be
printed out when you print the instrument configuration.
Data acquisition interface
The data acquisition is performed as it was described for the user defined
detectors via the interface box or the Manager 5000/5050. Select the
connected interface from the pull down menu. Most of the Kontron
detectors do not support data acquisition via serial port; therefore the A/D
converter is required.
Channel 1 Input:
Select the connected data channel of your interface.