ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

146 Creating an Instrument Control Method
Fig. 218 UV-Detector status tab, example: S 2500
The only exception is the Direct Control Area of the fixed wave detectors.
Fig. 219 UV-Detector status tab, Direct Control: S 200
Monitor
Run Status
The status HOLD will be displayed when no program is running;
otherwise the Run Status displays a run time in minutes elapsed from the
start of the run.
Signal (µAU)
The actual signal is indicated in this field.
Wavelength (nm)
The actual wavelength is indicated in this field.
Direct Control
The direct control option must be activated (see Fig. 249 on page 170).
D2 Lamp
The On state of the lamp is represented by an active green LED symbol
( ), the Off state is represented by an inactive grey LED symbol ( ).
Clicking on the Lamp Off button will (after inquiry) switch the lamp off
and change the button label to Lamp ON.
Autozero
Click this button to define the current signal as the baseline zero level.
Wavelength (nm)
Specify the wavelength you would like to have at the moment and click
the Apply button.