ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

32 Setup and Control of Knauer HPLC Systems
Fig. 30 Selection window for interface configurations
Knauer Interface Configuration
If you are using either a Knauer Interface Box/IF2 or a Manager
5000/5050, click on the corresponding icon, and then click Properties. A
dialog box will appear where you can configure the Interface Box (see
Fig. 32).
In regards to Knauer software, the Manager 5050 interface module is
identical to the Manager 5000. To configure the Manager 5050,
please select „Manager 5000“.
If you configure the interface newly, the message like Fig. 31 will remind
you to enter the serial number of the interface device.
Fig. 31 Error message for missing serial number
Click OK and perform the required settings. The same message will
appear if you try to close the setup window without an entered serial
number.
Fig. 32 Dialog box for configuring the Manager 5000/5050
The Knauer Interface Box and the Manager 5000/5050 require the same
parameters to be set up. Therefore, the configuration dialogs for both
devices are nearly identical.