ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Creating an Instrument Control Method 161
Events: (Status)
The three digits show how the events have been set in the “Events /
Digital Output Control” menu (This may not the current status of the
Events, if this settings have not been send by clicking the button.
The current status of the events will be represented by the LED symbols
on the top of the ASM 2.1L status window.)
Click on the button to setup the events (digital outputs). Refer to the
chapter Instrument Setup – Pumps, Pump section Configuring Digital
Outputs for details. Click on the button to send the settings to
the device.
Pump Purge ->
Click on the button to open the purge setup window. Please refer to
the chapter Instrument Status – Pumps for more information.
UV Diagnostics ->
Click on the button to open the UV diagnostics window. Please refer to
the chapter Instrument Status – Detectors for more information.
Instrument Status – Autosampler
Only one autosampler can be included in any system, therefore all
supported samplers will be explained separately without cross references
Instrument Status – Autosampler 3800
Smartline Autosampler 3800 and K-3800 (Basic Marathon)
Fig. 239 Autosampler 3800 status tab
Monitor
AS Status
The status Ready will be displayed when the autosampler is waiting to
perform an injection. If an injection program is running, the actual
program step will be indicated. After a completed injection, the status is
described as Analysis timer running during the chromatographic run.
Current Vial
The actual position of the injection needle is shown.
Tray Temperature (°C)
If the cooling option is installed and configured the actual tray
temperature will be shown.