ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

42 Setup and Control of Knauer HPLC Systems
Fig. 53 LAN interface Device Information window
Serial Number
If you have read-out the device via LAN, the serial number has been
added automatically. Otherwise type in the serial number of the pump
you are using. The serial number of network controlled pumps is used for
the device identification and addressing during communication. This
serial number must match the serial number of the defined pump. If not,
you will get an appropriate error message if you later try to start in run.
Head
Select the type of pump head you are using from the drop-down list. The
pump head must also be selected in the pump’s own menu. For the
pumps K-1001, K-1000, K-501 and K-120 pumps the choices are 10 ml
and 50 ml of different materials (steel, PEEK, ceramics, titan).
Fig. 54 Available pump heads for K-1001, K-1000, K-501, and K-120 pumps
For the pumps S 1000, 1050, S 100 and 10P/20P/P2.1S/P4.1S only
10 ml or 50 ml is to select, not considering the material. The pump P2.1L
and the preparative pump 1800 can be equipped with four different pump
heads with 100, 250, 500 or 1000 ml respectively. In case of titanium
inlays also select the only available steel pump head for the preparative
pump 1800.
Fig. 55 Available pump heads S 1000 / 1050 / 100
A B
Fig. 56 Available pump heads P2.1L (A ); preparative pump 1800 (B)
Once you have chosen the pump head, the related information about
material, maximal flow and maximal pressure is displayed automatically.
If you have read-out the device via LAN, the pump head type has been
selected automatically.