ChromeGate 3.3.2 Software Manual - KNAUER Advanced Scientific ...

Setup and Control of Knauer HPLC Systems 73
Fig. 101 Configuration windows for the autosamplers Triathlon and Endurance
Name
Enter a descriptive name for the sampler. This name will appear on the
autosampler tab when the instrument setup or status windows are
displayed. Use a name which is unique within the instrument.
Serial Number
Type in the serial number of the autosampler you are using.
Device ID
Select the device identifier for the autosampler from the drop-down list.
This must match the settings of the autosampler being used. To check
the device identifier for the Triathlon or Endurance autosampler, press
the SYSTEM, MENU and then buttons
on the autosampler keyboard.
Serial Port
Select the number for the communication port on your PC where the
autosampler is connected.
Loop Volume
Enter the volume of the installed loop in µl.
Tubing Volume
Enter the volume of the installed needle and tubing in µl. If the original
tube is installed, you can find the tubing volume on a label on the tube.
Syringe Volume
Select the volume of the installed syringe from the drop-down list. The
choices are 100 µl, 250 µl, 500 µl, 1000 µl, and 10000 µl. The 10000 µl
syringe can only be selected when a user defined injection method is
used.
Solvent Selection Valve (SSV) Option
Check this box if you have a solvent selection valve installed.
Tray Cooling
Check this box if you want to control the tray cooling. The setting of the
appropriate temperature will be done later as part of the instrument setup.
Tray...
Click the Tray button to set up the autosampler tray. The tray
configuration dialog will depend on the autosampler type (see below).