User's Manual - Kitagawa Europe

MAC mini iH Series Operation ManualOperation6.2.4.To stop programtemporarily duringexecutionStop the auto run temporarily during execution.When the program is stopped temporarily from the pendant.! Stop the program temporarily duringoperation.When the program is stopped temporarily by external signal.Turn OFF SP ofexternal STOP signal.! The operation content is the same as above. During TEMP. STOP, both LEDs of STATUS RUN and STOP light.6.2.5.To restart programduring TEMP. STOPRestart the program stopped temporarily by STOP inputting mode.When the program is restarted from the pendant panel.+ ENABLE switch! Remained program that the program isstopped because of TEMP. STOP is operatedautomatically.When the program is restarted by the external signal.Turn ON SP ofexternal STOP signal.Turn ON ST ofexternal START signal.! Release the STOP signal from the externalequipment.! The operation content is the same as above. During auto run, STATUS RUN LED lights. When the auto run by 1-block is completed, STATUS RUN LED goesout and STOP lights.6.2.6.Program interruption Interrupt the program during execution to stop the operation.When the program is interrupted from the panel.! Stop the operation during auto run to reset it.When the program is interrupted by the external signal.Turn ON RST ofexternal RESET signal.! The operation is stopped during automaticoperation to reset the machine. After resetting, STATUS RESET LED lights. The block of program returns to a top line (N000).KITAGAWA O6-3