User's Manual - Kitagawa Europe

DiagnosticsMAC mini iH Series Operation Manual1-axis spec.Channel チャンネル No. 番 号Command 指 令 角 度 angleBlock ブロック No. 番 号2-axis spec.Channel No.Command work coordinate displayCommand angleBlock No.Command work coordinate displayAs shown the above, only A-axis is displayed at 1-axis spec. MAC miniiH / iHF. Both axes are displayed on a screen (A-axis on upper stage,B-axis on lower stage) at 2-axis spec. (MAC mini iH2 / iHT series)This display method is common to a general diagnosis screen.7.1.3.I/O diagnostic displaycontent confirmationOn the diagnostic screen of I/O system, the I/O condition is displayed with1ON0OFF. The under bar located under 1 or 0 shows thesignal content.! Feeds the signal content to right. At this time, under the signal condition display 10is shifted in order.When keying in at the right edge, the signal is shifted to left.! Feeds the signal content to left. At this time, under the signal condition display 10isshifted in order.When keying in at the left edge, the signal isshifted to right. ! The left top signal is selected.O7-2 KITAGAWA