User's Manual - Kitagawa Europe

MAC mini iH Series Parameter・Expansion Manual ParameterPRM025 [ NAME ] 360FIN Output Spec.[ MESSAGE] 360FIN OUTPUT SPEC【DATA RANGE】 : 0,1Description Selects the output format of 360FIN signal.【 0 】 : One Shot OUTPUTOutputs 360FIN signal by a time set to PRM036 when the table stops atWZERO position or passes through its position.【 1 】 : Continuous OUTPUTThis mode monitors a current position usually, outputs 360FIN signalwhen the table is in set range (PRM026) and turns OFF the OUTPUTwhen the table is not in the set range.For detailed CONT. OUTPUT, see PRM026.PRM025=0 In passing through WZERO POS. PRM025=0 In stopping at WZERO POS.WZERO POSWZERO POSREV.REV.WZERO POS CHECK(360FIN)PRM036WZERO POS CHECK(360FIN)PRM036Precautions 1. To make this parameter valid, turn OFF power once.Concerned parameters PRM026,PRM034PRM026 [ NAME ] 360°FIN Output Area[ MESSAGE] 360FIN OUTPUT AREA【DATA UNIT】 : deg【DATA RANGE】: 0.000~1.000 (PRM025=1)Description Sets the OUTPUT AREA to output 360FIN continuously in PRM025=1.The PRM026 is set at ±range on the basis of WZERO position.PRM025=1Table motion in rightchart timing.360FINOUTPUT AREAWZERO POSTiming chart in operation as shown in left figure.REV.360FIN OUTPUT AREAWZERO POS CHECK(360FIN)PRM026SET VALUEPRM026WZERO POSPRM026PRM256Chattering prevention timerKITAGAWA P1-23